Trouble Display - Paradox Magellan MG5075 User Manual

Magellan & Spectra SP • Installation Guide

Trouble Display

Your alarm system continuously monitors several trouble conditions that can be reported directly to your monitoring station. When a trouble condition occurs, the
[ ] key will illuminate. Press the [
TBL
Loss trouble, contact your monitoring station or installer to resolve the trouble condition.
NOTE: If the keypad emits a
BEEP
Accessing the Trouble Display
Key / LED Lit
[1]
[2]
[3]
[4]
[5]
Press [ ]
TBL
[6]
[7]
[8]
[9]
[0 (10)]
[16] / [ ]
SLEEP
] key, and the keypad will illuminate a number corresponding to the trouble the system is experiencing. Except for the Timer
TBL
every 5 seconds whenever a new trouble condition has occurred, press the [
Trouble Type
Wireless Zone Low Battery
Power Trouble
Bell Trouble
Communication Trouble
Tamper/Zone Wiring Failure
Module Tamper Trouble
Fire Loop Trouble
Timer Loss
Wireless Zone Supervision Loss
Module Supervision Loss
Keypad Fault
] key to stop the "Trouble Beep".
TBL
Trouble Details
The batteries for one of the system's wireless devices needs to be replaced.
The control panel is experiencing power trouble.
There is a bell disconnect/overload on the control panel.
Your alarm system, if monitored, could not communicate with the monitoring
station.
A wiring problem is occurring on one or more devices.
A device's anti-tamper switch has been triggered.
One of the zones is in fire loop trouble.
Your alarm system's clock must be reprogrammed. See Setting the Time and
Date on page 7 to set your system's time and date.
One or more wireless zones are no longer communicating with the system.
One or more modules are no longer communicating with the system.
There is a problem with one of your system's keypads
| 9