Table of Contents
Advertisement
IMPORTANT: Trolling motors stored in temperatures below 0 °C (32 °F) should be
operated slowly for a minimum of 15 minutes before going above 30% operation.
Lubricating the Pivot Points
To reduce friction, lubricate the following pivot points periodically:
•
Pivot pin
•
Latch pin
•
Tilt positioning pin/lever
•
Tilt positioning pin/lever spring
IMPORTANT: Never use an aerosol lubricant to grease or oil any part of the unit.
Many aerosol lubricants contain harmful propellants that can cause damage to
various parts of the trolling motor.
Tube Ref No.
Description
2-4-C with PTFE
95
Battery Inspection
The battery should be inspected at periodic intervals to ensure proper trolling motor
operation.
IMPORTANT: Read the safety and maintenance instructions which accompany your
battery.
1. Ensure that the battery is secured to the vessel.
2. Ensure that the battery cable terminals are clean, tight, and correctly installed.
For installation instructions, refer to Battery Connection.
3. Ensure that the battery is equipped with a battery box to prevent accidental
shorting of the battery terminals.
Propeller Replacement
Performing service or maintenance without first disconnecting the battery can
cause product damage, personal injury, or death due to fire, explosion, electrical
shock, or unexpected motor starting. Always disconnect the battery cables from the
battery before maintaining, servicing, installing, or removing motor components.
REMOVING THE PROPELLER
1. Disconnect the power cables from the battery.
2. While holding the propeller blade with one hand, use a prop wrench to remove
the propeller nut.
MAINTENANCE
Where Used
Pivot points
WARNING
!
18
Part No.
92-802859A 1
eng
Advertisement
Table of Contents
