Field Replaceable Unit Procedures - KVH Industries LF Owner's Manual

5.4 Field Replaceable Unit
Procedures
The following subsections provide detailed procedures for
repairing or swapping out field replaceable units. The procedures
refer to labeled items presented on the following diagrams.
PCB Cover
3.15-amp Fuse
Antenna Gyro
(TracVision LF only)
Linear Actuator
54-0194 Rev. D
Pan Head Screws
PCB
Rotating Plate
Connecting Rod
Elevation Axis
Motor Shaft
Maintenance
Always lift the antenna unit by
the gray baseplate, never by the
radome or any portion of the
antenna assembly!
Figure 5-1
Antenna, PCB, and Rotating Plate
Before servicing the antenna unit,
be sure to remove the appropriate
vehicle fuse to disconnect power.
Replace the fuse after completing
the service.
Figure 5-2
Close-up of Connecting Rod
and E-ring
E-ring
5-3