Tracking The Correct Satellite; Using The Ird For Satellite Selection; Using The Switchplate For Satellite Selection - KVH Industries LF Owner's Manual

4. If your TV does not show a clear picture, the
antenna is tracking the wrong satellite. Refer to
Section 3.2.2, "Using the Switchplate for Satellite
Selection," for instructions on selecting a different
satellite.
3.2

Tracking the Correct Satellite

If your system is connected to an IRD's low-speed data port,
follow the steps in Section 3.2.1, "Using the IRD for Satellite
Selection." If your system is not connected to an IRD's low-speed
data port, follow the steps in Section 3.2.2, "Using the Switchplate
for Satellite Selection."

3.2.1 Using the IRD for Satellite Selection

If your TracVision LF/SF is connected to an IRD's low-speed data
port, the antenna will automatically find and track the correct
satellite based on the information it receives from the IRD. No
user interaction is required.
3.2.2 Using the Switchplate for Satellite
Selection
If your system is not connected to an IRD's low-speed data port,
you will need to use the switchplate to manually find your
satellite.
1. Press the switchplate's SAT SELECT button.
2. The Status indicator flashes while the antenna
searches for a satellite signal. Once the antenna
finds and starts tracking a satellite, the Status
indicator stops flashing.
3. If your TV shows a clear picture, you are tracking
the correct satellite. If no picture appears, repeat
this procedure starting with Step 1.
54-0194 Rev. D
Using Your TracVision LF/SF
If your antenna is unable to find the
desired satellite, refer to Section 4,
"Troubleshooting," for possible
causes and their corrective actions.
3-3