KVH Industries LF Owner's Manual page 22

Message
KVH TracVision
Software Version
Initializing
Search Mode 1
Search Mode 2
Search Mode 3
Reacquisition
RF Signal Error
AZ Motor Error
EL Motor Error
Ant Gyro Error
(TracVision LF only)
Cable Unwrap
Differences among IRD low-speed data ports may result in
different message formats, and some messages may not be
displayed on the television screen. DIRECTV messages you may
see are listed in Table 2-4.
Message
Searching for satellite –
please stand by
Searching for program guide –
please stand by
Refer to your DIRECTV User's Manual for specific messages
displayed by your system.
54-0194 Rev. D
Definition
Displays for 5 seconds at startup
Current software version
Alternates with "KVH TracVision"
System initializing
Antenna unit in Search Mode 1
Antenna unit in Search Mode 2
Antenna unit in Search Mode 3
System is reacquiring the satellite
RF signal detector has no signal at input
Fault detected in azimuth drive subassembly
Fault detected in elevation drive subassembly
Fault detected in antenna gyro assembly, OR
antenna gyro failed to initialize properly
because vehicle was turning during the
60-second startup and initialization period
following power-up
System in process of unwrapping cable
Definition
The IRD is powered up and
doesn't detect the satellite signal.
The system has found the satellite,
but has been turned off for more
than approximately four hours. This
message appears for about
10 seconds.
Table 2-3
TracVision LF/SF Operational
Messages
The DISH Network and some
newer IRDs (e.g., the Sony A50)
give priority to internal IRD
messages rather than on-screen
messages. KVH recommends that
the maintenance port be used to
read installation-related messages
on a PC (see Section 2.5.2,
"Checking Out the System Without
an IRD Data Connection").
Table 2-4
DIRECTV On-screen Messages
Installation
2-11