Things To Check Before You Call For Service - Culligan HE Twin Water Softener Owner's Manual

Things to
Check Before
You Call for
Service
01023052
46
If you unexpectedly experience changes in your water, make these simple checks before calling your Culli-
gan deal er. One of the following conditions may be the reason for your interruption of service.
Important
If any of the following conditions is found, the water softener should be man u al ly regenerated according
to instructions on page <?> after you have corrected the problem.
Power Supply
Check your power supply cord. Is it plugged fully into the electric outlet? Be certain that the outlet is not
controlled by a wall switch which has been turned off. Plug in the transformer then reset conditioner to the
correct time of day.
Blown Fuse
Check the house fuse or circuit breaker panel. Replace a blown-out fuse or reset an open circuit breaker.
Power Failure
Any interruption in your power supply or time change—such as daylight savings—will disrupt your soften-
er's regeneration schedule by causing the timer to run off-schedule. Reset the timer to the correct time of
day.
Bypass Valves
Check to see if they are in the proper position. Cul-Flo-Valv
position (see page 21). If hand valves are used, see that inlet and outlet valve are opened and that the
bypass valve is closed.
No Water
If you aren't getting any water flow at all, make sure your water supply is work ing. Open a tap ahead of
the conditioner (outside tap) to see if you have any water pressure. If you have water pressure, check the
bypass valve. If it is in the Service position, put it into the bypass and call your Culligan dealer for service.
Increased Usage
Guests, family additions, new water-using appliances, etc., will result in more water usage and will require
more capacity from your softener. You can re pro gram your regeneration schedule by following the direc-
tions beginning on page 38. Call your Culligan dealer for advice and save a service call.
Bypass, if used, should be in the "Service"
®