Subaru 2004 Impreza Service Manual page 8

2) Install the 3rd drive gear, outer baulk ring, syn-
chro cone, inner baulk ring, sleeve and hub assem-
bly for 3rd needle bearing on transmission main
shaft.
NOTE:
Align the groove in baulk ring with shifting insert.
(D)
(A)
(B)
(A) 3rd needle bearing
(B) 3rd drive gear
(C) Inner baulk ring
(D) Synchro cone
(E) Outer baulk ring
(F) Sleeve and hub ASSY
3) Install the 4th needle bearing race onto trans-
mission main shaft using ST1, ST2 and a press.
NOTE:
Do not apply pressure in excess of 10 kN (1 ton, 1.1
US ton, 1.0 Imp ton).
ST1 899714110 REMOVER
ST2 499877000 RACE 4-5 INSTALLER
ST2
(A)
ST1
(A) 4th needle bearing race
Main Shaft Assembly for Single-Range
(E)
(F)
(C)
MT-00200
MT-00192
MANUAL TRANSMISSION AND DIFFERENTIAL
4) Install the baulk ring, needle bearing, 4th drive
gear and 4th gear thrust washer to transmission
main shaft.
NOTE:
Align the baulk ring and gear & hub assembly with
key groove.
(B)
(A) Groove
(B) 4th gear side
5) Drive the ball bearing onto the rear section of
transmission main shaft using ST1, ST2 and a
press.
NOTE:
Do not apply pressure in excess of 10 kN (1 ton, 1.1
US ton, 1.0 Imp ton).
ST1 899714110
ST2 499877000
5MT-77
(A)
MT-00193
REMOVER
RACE 4-5 INSTALLER
ST2
ST1
MT-00194