Subaru 2004 Impreza Service Manual page 27

MANUAL TRANSMISSION AND DIFFERENTIAL
8) Install a set of roller bearings onto the driven
shaft using ST and press.
NOTE:
Do not apply pressure in excess of 10 kN (1 ton, 1.1
US ton, 1.0 Imp ton).
ST 499277200 INSTALLER
9) Position the woodruff key in groove on the rear
of driven shaft. Install the 5th driven gear onto driv-
en shaft using ST and press.
NOTE:
Do not apply pressure in excess of 10 kN (1 ton, 1.1
US ton, 1.0 Imp ton).
ST 499277200 INSTALLER
10) Install the lock washer. Install the lock nut and
tighten to the specified torque using ST.
ST 499987300 SOCKET WRENCH (50)
Tightening torque:
260 N·m (26.5 kgf-m, 191.7 ft-lb)
Drive Pinion Shaft Assembly
ST
MT-00256
ST
MT-00257
ST
MT-00258
5MT-96
NOTE:
• Stake the lock nut at two points.
• Using the spring balancer, check that starting
torque of roller bearing is 0.1 to 1.5 N (0.01 to 0.15
kgf, 0.02 to 0.33 ft).
11) Install the roller bearing onto drive pinion.
NOTE:
When installing the roller bearing, note its direc-
tions (front and rear) because the knock pin hole in
outer race is offset.
(A) Roller bearing
(B) Knock pin hole
12) Install the washer using ST1, ST2 and press.
NOTE:
• Discard the old lock nuts, replace with new ones.
• Secure the lock nut in four places.
ST1 499277100 BUSH 1-2 INSTALLER
ST2 499277200 INSTALLER
(A) Washer
MT-00259
(A)
(B)
MT-00260
ST2
ST1
(A)
MT-00261