Subaru 2004 Impreza Service Manual page 28

13) Install the thrust bearing and needle bearing.
Install the driven shaft assembly.
14) Install the drive pinion collar, needle bearing,
adjusting washer No. 2, thrust bearing, adjusting
washer No. 1 and differential bevel gear sleeve in
that order.
NOTE:
Be careful because the spacer must be installed in
proper direction.
(A) (B)
(C) (D) (E) (F) (G) (H)
(A) Driven shaft
(B) Drive shaft
(C) Drive pinion collar
(D) Needle bearing (25 × 30 × 20)
(E) Washer No. 2 (25 × 36 × 4)
(F) Thrust bearing (25 × 37.5 × 3)
(G) Washer No. 1 (25 × 36 × t)
(H) Differential bevel gear sleeve
2. FWD MODEL
1) Assemble gear and hub assembly.
NOTE:
• Use new gear and hub assembly, if gear or hub
have been replaced.
Drive Pinion Shaft Assembly
• Be sure the insert keys are correctly located in
the insert key grooves inside the reverse driven
gear.
MT-00262
MT-00263
2) Drive roller bearing onto drive pinion shaft and
1st driven gear thrust washer using ST1 and ST2.
ST1 499277000
ST2 499277100
CAUTION:
Use new roller bearing, 1st gear thrust washer.
3) Install 1st-2nd driven gear bushing onto drive
pinion shaft.
5MT-97
MANUAL TRANSMISSION AND DIFFERENTIAL
(A)
(C)
(D)
(E)
(F)
(A) Key grooves
(B) Reverse driven gear
(C) 1st driven gear side
(D) 2nd driven gear side
(E) Flush surface
(F) Stepped surface
RACE 4-5 INSTALLER
BUSH 1-2 INSTALLER
(A) Thrust washer
(B)
MT-00827
ST1
ST2
(A)
MT-00828