Subaru 2004 Impreza Service Manual page 19

MANUAL TRANSMISSION AND DIFFERENTIAL
6) Remove the snap ring.
(A) Snap ring
7) Using a press and ST, remove the ball bearing.
NOTE:
Remove the inner snap ring before pressing.
ST 498077000 REMOVER
S T
8) Remove the oil seal from input shaft holder.
D: ASSEMBLY
1) Install the ball bearing onto input shaft.
NOTE:
Place the snap ring between input shaft gear and
ball bearing beforehand. Use the table at 8) as a
guide in selecting a suitable snap ring.
ST1 899580100 INSTALLER
ST2 399513600 INSTALLER
Input Shaft Assembly
( A )
MT-00230
MT-00231
ST1
ST2
MT-00232
5MT-88
2) Install the snap ring on input shaft.
(A) Snap ring
3) Inspect the clearance between ball bearing and
snap ring. <Ref. to 5MT-89, INSPECTION, Input
Shaft Assembly.>
4) Install the straight pin and oil squeeze plate to in-
put shaft.
(A) Straight pin
(B) Oil squeeze plate
5) Install the snap ring.
6) Drive the oil seal into input shaft holder.
NOTE:
Apply a coat of grease to sealing lips before install-
ing oil seal.
ST 398507703 DUMMY COLLAR
( A )
MT-00230
(A)
(B)
MT-00234
ST
MT-00235