Subaru 2004 Impreza Service Manual page 7

MANUAL TRANSMISSION AND DIFFERENTIAL
9) Install the synchro cone stopper and snap ring to
5th-Rev sleeve and hub assembly.
(A) Synchro cone stopper
(B) Snap ring
10) Install rest of the parts to the rear section of
transmission main shaft.
NOTE:
Align the groove in baulk ring with shifting insert.
(A) (B) (C)
(A) Needle bearing
(B) 5th drive gear
(C) Baulk ring
(D) 5th-Rev sleeve and hub ASSY
(E) Lock washer
(F) Lock nuts
11) Tighten the lock nuts to the specified torque us-
ing ST1 and ST2.
NOTE:
Secure the lock nuts in two places after tightening.
ST1 499987003 SOCKET WRENCH
ST2 498937000 TRANSMISSION HOLDER
Tightening torque:
120 N·m (12.2 kgf-m, 88.5 ft-lb)
Main Shaft Assembly for Single-Range
(B)
(A)
MT-00188
(D)
(E)
(F)
MT-00198
5MT-76
2. AWD TURBO MODEL
1) Assemble each sleeve and hub assembly.
NOTE:
Position the open ends of spring 120° apart.
(A)
(B)
(C)
(D)
(A) 3rd-4th hub ASSY
(B) 3rd gear side
(C) 5th-Rev hub ASSY
(D) 5th gear side
MT-00191