Main Fuse; Fuses For Individual Power-Consuming Units; Exchanging The Headlight Lamp; Replacing The Parking Light Bulb - KTM Supermoto 400/640LC4-E6 Owner's Handbook Manual

1
2
5
6
7
10

Main fuse

Located near the battery under the seat, the main fuse
consumers.
Replace a blown fuse only with an equivalent one. If a new fuse that has
just been set in gets blown again, you are strongly advised to have it
inspected by a KTM dealer.
The fuse capacity is 20 Ampere.
U
NDER NO CIRCUMSTANCES IS A STRONGER FUSE ALLOWED TO BE SET IN OR A FUSE
ALLOWED TO BE
ELECTRICAL INSTALLATION

Fuses for individual power-consuming units

3
Additional fuses separately protecting different power-consuming units are
mounted under the headlight mask.
For instructions to remove and mount the headlight mask please refer to

"Exchanging the headlight lamp".

4
Fuse 2
– headlight
– parking light
3
Fuse
– flasher lights
– brake light
– horn
– radiator fan motor
Fuse 4
– ignition
– starter system
Replace a blown fuse only with an equivalent one. If a new fuse that has
just been set in gets blown again, you are strongly advised to have it
inspected by a KTM dealer.
U
NDER NO CIRCUMSTANCES IS A STRONGER FUSE ALLOWED TO BE SET IN OR A FUSE
ALLOWED TO BE
ELECTRICAL INSTALLATION
Exchanging the headlight lamp
Remove the headlight mask:
Remove screws
Depress the front section of the fender, pull the headlight mask upwards,
8
unhook it from the lower part of the fender, then swing it forwards.
Exchanging the headlight lamp
Disconnect plug
Remove the rubber cap
Unhook the retaining bracket, then remove the bulb.
When inserting the new bulb make sure that the wider of the 3 tongues
is located in the corresponding groove in the socket.
N
EVER TOUCH THE GLASS OF THE BULB WITH YOUR FINGERS
MUST REMAIN ABSOLUTELY FREE FROM GREASE
GREASE TO EVAPORATE AND SETTLE DOWN ON THE REFLECTOR
Hook in the retaining bracket, mount the rubber cap and connect the plug
to the bulb.
Mounting the headlight mask
Appropriately position the headlight mask. The headlight must be
located below the cockpit.
Depress the front part of the fender, pull the headlight mask upwards and
insert the retaining pins
Mount the screws
9
Replacing the parking-light bulb
Disassemble the headlight as described above and simply pull the bulb
socket
! CAUTION
" ". A
REPAIRED N INEXPERT TREATMENT COULD DAMAGE THE WHOLE
!
(10 Ampere) protects the following power-consuming units:
(10 Ampere) protects the following power-consuming units:
(10 Ampere) protects the following power-consuming units:
CAUTION
!
" ". A
REPAIRED N INEXPERT TREATMENT COULD DAMAGE THE WHOLE
!
5
on the left and on the right side.
6
from the bulb.
7
! CAUTION
9
into the corresponding bores of the fender.
5
.
bk
out of the reflector.
1
protects all power
!
!
!
. T
HE GLASS OF THE BULB
. H
EAT WILL OTHERWISE CAUSE THE
.
27
8