Serial Number Locations; Chassis Number; Engine Number, Engine Type; Operation Instruments - KTM Supermoto 400/640LC4-E6 Owner's Handbook Manual

1
1-3 mm
2

SERIAL NUMBER LOCATIONS

Chassis number

The chassis number is stamped on the right side of the steering head tube.
Write this number into the relevant area on page 1.

Engine number, engine type

The engine number and engine type are stamped on the right hand side of
the engine below the chain sprocket. Write this number into the relevant
area on page 1.

OPERATION INSTRUMENTS

Clutch lever

1
The clutch lever is fitted on the left hand side of the handle bar. When
engine is cold, there should allways be a play of 1–3 mm (0,04–0,1 in) at
this lever (measured at outer edge).
!
I
F THERE IS NO PLAY ON THE CLUTCH LEVER
,
CLUTCH WILL THEN OVERHEAT DESTROYING THE CLUTCH LININGS

Hand decompression lever

The hand decompression lever
a) When the engine stalled.
It is possible that the starter motor is not able to crank the engine on the
next attempt. This is due to the fact that the automatic decompressor
doesn't work properly. If this happens, pull the manual decompression
lever and start again. Afterwards normal starting will be possible.
b) When you want to push the motorcycle.
While pushing, pull the hand decompression lever to make it easier to get
the engine going.
!
T
HE SETTING OF THE HAND DECOMPRESSION CABLE SHOULD BE REGULARLY CHECKED
( ). A
SEE MAINTENANCE WORK LACK OF PLAY IN THE HAND DECOMPRESSION LEVER CAN
.
RESULT IN ENGINE DAMAGE
CAUTION
,
THE CLUTCH WILL START TO SLIP
.
2
is only used in two special cases:
CAUTION
5
!
. T
HE
!