Space-Ray PTS 40-N7/L7 Installation And Operation Instructions Manual page 28

3. Hold the spring retainer clamp and pull the TISS
spring retainer clamp over end of reflector as shown.
Step 3
4. After attachment of the TISS
diagram below to increase or decrease the tension as necessary. diagram below to increase or decrease the tension as necessary.
diagram below to increase or decrease the tension as necessary. diagram below to increase or decrease the tension as necessary.
Step 4
Form 43343530
Aug 2012
TISS wire assembly to end of reflector at overlap joint. Slide
TISS TISS
TISS, check to make sure that there is sufficient tension on the wire. Follow the TISS TISS
-27-
Follow the Follow the Follow the