12.1)
ATTACHING BURNER BOX ASSEMBLY
1. Attach the burner box and gasket to end of tube flange and secure with 1/4-20 locknuts.
2. Assemble the optional end reflector flush with the end of the main body reflector. Secure by sliding speed
clips onto the reflector edges. Evenly space the speed clips on the sides (one each side) and top (two
required) of the reflectors to provide a snug fit. Leave a 3" space between the end reflector and the burner
box assembly.
3. The heater can be mounted horizontally
When angle mounting, the burner
control box in an UPRIGHT position will VOID the manufacturer's warranty. . . .
control box in an UPRIGHT position will VOID the manufacturer's warranty
control box in an UPRIGHT position will VOID the manufacturer's warranty
control box in an UPRIGHT position will VOID the manufacturer's warranty
Form 43343530
Aug 2012
horizontally or at an angle of up to 45
horizontally
horizontally
burner box unit must
burner
burner
must be positioned upright
must
must
-25-
45 degrees
45
45
degrees maximum from horizontal.
degrees
degrees
upright as shown below Failure to install the
upright
upright
Failure to install the
Failure to install the
Failure to install the