Assembly Of Tube Sections - Space-Ray PTS 40-N7/L7 Installation And Operation Instructions Manual

Infrared radiant tube heater two stage push through system (positive pressure)

Table of Contents

10.0)

ASSEMBLY OF TUBE SECTIONS

During field assembly of the heater body sections, the recommended procedure is as follows:

1. Before hanging heater sections, first determine the actual layout of the system (see Sections 7.0) & 8.0) for

details). Consideration must also be taken for flue pipe, fresh air ducting, gas piping, clearances to

combustibles, etc. before hanging heater. Typical suspension methods are shown in Section 9.0).

2. Hang each tube section individually. DO NOT attach the heater tube sections together on the ground and

attempt to hang the entire system.

3. In all configurations, the burner box must be connected directly to either a) the 24-hole flange of the 10 ft.

aluminized steel starting body section (for 10 ft., 20 ft., and 30 ft. systems) or b) the 6-hole flange of the 10

ft. alumi-therm steel starting body section (for 40 ft., 50 ft., 60 ft., and 70 ft. systems.

4. Assemble a tube support/hanger bracket 4" from the end of the heat exchanger tube having the mounting

flange. Align the tube such that the welded seam is facing down toward the ground.

5. Suspend the chain to attach the wire hanger and the tube support bracket. Insert the tube into the wire

hanger and then raise the tube support bracket end up to the suspension chain, use "S" hooks to attach the

wire hanger and tube support bracket to the chain.

F F F F ailure to assemble the tube with the seam facin

ailure to assemble the tube with the seam facing down will VOID the

ailure to assemble the tube with the seam facin

manufacturer's warranty.

-18-

g down will VOID the

Form 43343530

Aug 2012

Table of Contents