Seam Program Input With The "Teach-In" Function - Pfaff 3834-14/11 Instruction Manual

Input
11

Seam program input with the "Teach-in" function

.01.03
With this function the seam program is created by sewing a sample. A new program is
always created, i.e. if an existing program is selected, this will be overwritten.
● Switch on the machine.
● Select a program number from 3 – 49, see Chapter 9.07 Selecting a program number.
● Call up the input mode.
● Call up the "Teach in" function.
● Carry out the basic settings and conclude with the "Enter" function, see Chapter 11.01.01
Before sewing starts the following displays and functions appear on the screen.
● Set the top feed stroke (roller presser).
2.7
● Enter the basic value for the thread tension.
+0
● Enter the graduated value.
3.0
● Enter the start backtacks (function at beginning of seam) see Chapter 9.10 Entering the
● Sew the first seam section using the pedal function.
11 - 6
Basic setting for seam program input.
49 1
1
The difference to the feed stroke of the feed wheel (basic stitch length) determines the
fullness.
The actual value of the thread tension is composed of this basic value and ,if applicable,
the manual alteration in programmed sewing.
The graduated value (in mm) is used to adapt different garment sizes to the programmed
basic size.
start and end backtacks.
The length of the seam section is calculated from the stitch length and the number of
stitches and is shown on the display in millimetres.
1 2.5
2.7 +0
3.0