Save All/Exit - HIKVISION DS-2CC5281P User Manual

High-definition Vandal-proof Dome Camera· User Manual
The defective pixel correct function may not be displayed on the
menu; you can enable the function by following the steps below.
Steps:
1. Exit the OSD menu to the live view screen.
1. Switch and hold the menu button to the left for 2 seconds until
you see the message of "COVER-UP LENS/CLOSE IRIS".
2. Cover the lens or close the iris to prevent the light from
entering the lens.
3. Press the menu button to confirm. You w ill be able to see the
bright dot detects on the grainy screen.
4. After the process, the bright dot defects will disappear and you
can see "SUCCESS" on the screen.
5. Press the menu button to exit.
Note: An ERROR may occur because that the lens was not fully
covered. Please repeat above steps to try again.

3.17 Save All/Exit

Move the cursor to the Exit, and press the menu button to exit the
settings without saving.
Move the cursor to SAVE ALL, and press menu button to save the
settings and exit.
43