Aria Child Asana 35 User Manual page 43

Route the lap belt through the belt
path openings on both sides of base and
under the FirmFit arm. Make sure not to
twist the belt and make sure it lies flat.
Fasten the buckle until it clicks into place.
Pull the lap belt to remove all the slack
and to get the base snug against the
vehicle seat. Lay the free end of the belt
across the belt path so it will be under
the FirmFit arm after it has been closed.
Close the FirmFit arm until it locks into
place and you see GREEN in the
indicator window.
CHECK to make sure base is secure by
holding both sides of the base near the
vehicle belt and moving it from side to
side and front and back. The lap belt
should not loosen and the base should
not move easily. The base should not
move more than 1 inch (2.5 cm) from
side to side or front to back.
4
5
6
43
CLICK!
CLICK!