Checking The Basic Setup Of The Telescopic Fork; Changing The Spring Preload On The Telescopic Fork (Sx Models)27; Changing The Spring Preload On The Telescopic Fork (Mxc/Exc Models).27; Replacing Fork Springs - KTM 125 Owner's Handbook Manual

PDS 1218X757
200 SX/MXC/EXC
66-86/260
60 65 70 75
RIDERS WEIGHT INCLUSIVE GEARS IN KILOGRAM
1418X725
1418X736
250/300 MXC/EXC
4,0 N/mm
3,8 N/mm
60 65 70 75
RIDERS WEIGHT INCLUSIVE GEARS IN KILOGRAM
1418X735
200 SX/MXC/EXC
3,8 N/mm
3,6 N/mm
60 65 70 75
RIDERS WEIGHT INCLUSIVE GEARS IN KILOGRAM
According to our experience, the damping rate of the compression stage
125 EXC
can remain unchanged. The damping rate of the rebound stage can be
reduced by a few clicks for a softer spring or increased by a few clicks for a
harder spring.
71-90/260
80 85 90

Checking the basic setup of the telescopic fork

The precise riding sag of the telescopic fork cannot be determined for
various reasons. Similar to the shock absorber, smaller deviations in your
weight can be compensated by adjusting the spring preload. However, if
your telescopic fork bumps frequently (hard end stop during compression),
you should install harder fork springs to avoid damaging the telescopic fork
and frame.
Changing the spring preload on the telescopic fork (SX models)
The telescopic forks of the SX models come with a preload adjuster for easy
adjustment of the spring preload. You can adjust the spring preload ± 9 mm
by turning the adjusting screws (basic position = middle position).
NOTE:
Always turn the adjusting screws the same distance on both fork legs. Diffe-
rent spring preloads on the fork legs will reduce the telescopic fork's res-
ponse.
Changing the spring preload on the telescopic fork
(MXC/EXC models)
The telescopic forks for these models must be partly disassembled to adjust
the spring preload (see WP manual). Pretension spacers are available in
heights of 1.5, 2.5 and 5 mm (see spare parts catalog). The fork springs
125 SX
may not be pretensioned by more than 20 mm.
The preload adjuster used in the SX models can easily be retrofitted for the
telescopic forks of the MXC/EXC models.
NOTE:
WP precisely adjusts the spring pressure by inserting pretension spacers.
Fluctuations in production are compensated with pretension spacers in
4,2 N/mm
various heights. This can cause the fork springs in the fork legs to have dif-
ferent degrees of pretension. Fork springs and pretension spacers should
always stay together.
80 85 90

Replacing fork springs

125 EXC
If you weigh less than 70 kg or more than 80 kg, you should install the res-
pective fork springs. The correct spring rate is shown in the illustrations. The
standard spring is shown in bold print. The type number of the telescopic
fork is embossed on the caps on the top of the telescopic fork.
If you are uncertain which spring to use, contact your KTM workshop.
4,0 N/mm
According to our experience, the damping rate of the compression stage
can remain unchanged. The damping rate of the rebound stage can be
reduced by a few clicks for a softer spring or increased by a few clicks for a
harder spring.
80 85 90
27