User Interface - KTI Networks KS-2260 Operation Manual

Direct Console Management
When you can see the self-test messages shown on screen properly, you
can press <Enter> key to start console login operation. Go to Login
Prompt section in next page directly.
Telnet Management
Use Telnet software to perform the management operation. The most
convenient solution is using the built-in Telnet function in a Windows
95/98/ or NT PC. Enter into DOS window and invoke Telnet command :
to connect to the device. The specified xxx.xxx.xxx.xxx is the IP address of
the device. Factory default IP address is 192.168.0.2.
A welcome message and login prompt are displayed if the connection is
established properly.
Login Prompt
The following figure illustrates the login screen:
----------------------------------------------------
----------------------------------------------------
Username : admin
Factory default Password : 123
For security reason, the device supports a function to change the pass-
word in setup menu. It is recommended to change the default password
immediately after a successful login.
>telnet xxx.xxx.xxx.xxx

User Interface

Managed 24 + 2G Switch
login:xxxx
password:xxxx
-43-