Console And Telnet Operation - KTI Networks KS-2260 Operation Manual

3. Console and Telnet Operation

This chapter describes the detailed console operation. It can be applied
to either out-of-band console management or in-band Telnet manage-
ment. Refer to Chapter 2 for installation details.
Cold Start
When the power to the switch is turned on, the device start initialization
and self-test process. The self-test messages are displayed as follows if
a console connection is established successfully.:
Power-on Self-test Console message
---------------------------------------------
$$$ Switch LOADER Checksum O.K !!!
$$$ Press any key to
$$$ Switch IMAGE Checksum ...... O.K !!!
$$$ Loading IMAGE ...............................
$$$ Switch Power On Self Test...
$$$ CPU(arm7) Sdram Test Start..
++ Memory Test (Long) ....
++ Memory Test (Short) ...
++ Memory Test (Byte) ....
$$$ CPU(arm7) Sdram Test O.K !!!
$$$ Switch Register R/W Test ...O.K !!!
$$$ Phy Register R/W Test ...O.K !!!
$$$ Embedded Sram Built In Self Test ...O.K !!!
$$$ Switch Data Area Checksum ...O.K !!!
$$$ Detect Module Card... O.K !!!
$$$ Switch Engine Initialize...O.K !!!
$$$ Trunk Initialize...O.K !!!
$$$ Port Initialize...O.K !!!
$$$ BwCtrl Initialize...O.K !!!
$$$ Forwarding Initialize...O.K !!!
$$$ Vlan Initialize...O.K !!!
---------------------------------------------
Both console management and Telnet management are same in operation
starting from login prompt.
start Xmodem receiver:
O.K !!!
O.K !!!
O.K !!!
-42-