Table of Contents
Advertisement
DS-9500 Series NVR Quick Operation Guide
Verify Contents
Verify that the package contents are correct by checking the items against the packing list.
Note:
Please contact your dealer for damaged or missing items.
NVR Pre-Installation
The DS-9500 Series NVR is highly advanced surveillance equipment that should be installed with care. Please
take into consideration the following precautionary steps before installation of the NVR.
1. Keep all liquids away from the NVR.
2. Install the NVR in a well-ventilated and dust-free area.
3. Ensure environmental conditions meet factory specifications.
4. Install a manufacturer recommended HDD.
NVR Installation
During the installation of the NVR:
1. Use brackets for rack mounting.
2. Ensure there is ample room for audio and video cables.
3. When installing cables, ensure that the bend radius of the cables are no less than five times than its diameter.
4. Connect both the alarm and RS-485 cable.
5. Allow at least 2cm (~0.75in) of space between racks mounted devices.
6. Ensure the NVR is grounded.
7. Environmental temperature should be within the range of -10 ºC ~ 55 ºC, 14ºF ~ 131ºF.
8. Environmental humidity should be within the range of 10% ~ 90%.
Hard Disk Installation
Before installing a hard disk drive (HDD), please make sure the power is disconnected from the NVR. A factory
recommended HDD should be used for this installation.
Tools Required: Screwdriver.
1. Use the screws to install HDD to its mounting bracket.
2. Press the latches on both sides of the front panel of NVR chassis to open it.
3. Inser the HDD bracket to the chassis along the slot unitl it has fully seated i nto pos ition.
4. Close the front panel of the NVR chassis.
1
Advertisement
Table of Contents
