Verify Contents; Dvr Pre-Installation; Hard Disk Installation; Dvr Installation - HIKVISION DS-9104HFI-ST Series Quick Operation Manual

Hide thumbs Also See for DS-9104HFI-ST Series:
Table of Contents

Advertisement

Quick Operation Guide of DS-9100/9000/8100/8000HFI-ST Series DVR
Thank you for purchasing our product. If there is any question or request, please do not hesitate to contact dealer.
This manual is applicable to
DS-9008HFI-ST, DS-9016HFI-ST; DS-8104HFI-ST, DS-8108HFI-ST, DS-8116HFI-ST; DS-8004HFI-ST,
DS-8008HFI-ST, and DS-8016HFI-ST series DVR.

Verify Contents

Verify that the package contents are correct by checking the items against the packing list.
Note:
Please contact your dealer for damaged or missing items.

DVR Pre-Installation

The DS-9100/9000/8100/8000HFI-ST Series DVR is highly advanced surveillance equipment that should be
installed with care. Please take into consideration the following precautionary steps before installation of the DVR.
1. Keep all liquids away from the DVR.
2. Install the DVR in a well-ventilated and dust-free area.
3. Ensure environmental conditions meet factory specifications.
4. Install a manufacturer recommended HDD.

DVR Installation

During the installation of the DVR:
1. Use brackets for rack mounting.
2. Ensure there is ample room for audio and video cables.
3. When installing cables, ensure that the bend radius of the cables are no less than five times than its diameter.
4. Connect both the alarm and RS-485 cable.
5. Allow at least 2cm (~0.75-inch) of space between racks mounted devices.
6. Ensure the DVR is grounded.
7. Environmental temperature should be within the range of -10 º C ~ 55 º C, 14º F ~ 131º F.
8. Environmental humidity should be within the range of 10% ~ 90%.

Hard Disk Installation

Before you start:
Before installing a hard disk drive (HDD), please make sure the power is disconnected from the DVR. A factory
recommended HDD should be used for this installation.
Up to 8 SATA hard disks can be installed on your DVR.
Tools Required: Screwdriver.
Steps (for DS-9100/9000HFI-ST):
1. Fasten the hard disk mounting handle to the hard disk with screws.
2. Insert the key and turn in clockwise direction to open the panel lock.
DS-9104HFI-ST, DS-9108HFI-ST, DS-9116HFI-ST; DS-9004HFI-ST,
1

Advertisement

Table of Contents
loading

Table of Contents