Diagnostic For Sensor And Driver - KNS Ku-BAND TX Installation And Operation Manual

Figure 7-36 Azimuth and Elevation Trim (Steps)
NOTE: Cage offset is configured by a SAMYUNG ENC engineer during factory setting.
The operator cannot change the cage offset, except the 'Azimuth and Elevation Trim'.
NOTE: The operator must save the changed parameters using 'SAVE NEW
PARAMETER'.
7.2.12
The operator can check the operating state of the antenna using 'Diagnostic for Sensor
and Driver'. The operator can see the following parameters.
ERROR: Antenna Pointing Accuracy Error of Elevation, Cross and Azimuth Axis (Unit:
Degrees)
DRIVING OUT: Motor Driving Torque of Elevation, Cross and Azimuth Axis
SEN ANG: Angle of Elevation and Cross Tilt Sensor, Angle of Azimuth Gyro Rate,
Encoder Value

Diagnostic for Sensor and Driver

90