Error Message - KNS Ku-BAND TX Installation And Operation Manual

10.

Error Message

If the antenna has problems, then error LED on ACU will come on. Press the 'ENT' key
to check the error code; then, the error code will be displayed as a hexadecimal on the
LCD panel of the ACU. If the antenna has more than two errors, the ACU will display
combined error codes. Table 10-1 is the general error code and error index.
NOTE: Please refer to Appendix A for further details. BUT, convert hexadecimal into
binary to use the Appendix A (Error code define).
Error Code
0x 01 00 00
0x 02 00 00
0x 04 00 00
0x 08 00 00
0x 10 00 00
0x 20 00 00
0x 40 00 00
0x 00 04 00
0x 00 10 00
0x 00 20 00
0x 00 40 00
0x 20 00 00
0x 20 00 00
0x 20 00 00
00
00 Cross-Level Axis Control Error
00
00
00 Satellite searching parameters are not correct.
00
00
00
00
00
00
01
02 Unknown RS232 error has occurred
03 Unknown or invalid command has been received
Error Index
Level Axis Control Error
Yaw Axis Control Error
GPS Error
Tuner Error
Yaw Encoder Index Error
Searching Failure
DSP Flash Writing Error
DSP EEPROM Error
RSSD PLL Error
System has restarted
107