Operation Using Front Key Pad; Configuration Mode; Key Mapping - KNS Ku-BAND TX Installation And Operation Manual

7. Operation using Front Key Pad

There are two modes in the ACU configuration: Configuration Mode and Install Mode.
In the Configuration Mode, the operator configures the parameters required for standard
operation. In the Installation mode, the installer configures the parameters required for
installation of the antenna and/or repair work.
7.1

Configuration Mode

This section will describe the configuration of the ACU.

7.1.1 Key Mapping

The following table provides a quick reference source on Key Mapping of the ACU.
Key (Main Status)
1
2
3
4
5
6
7
8
+/-
·
▲
▼
Holding 'ß' 3 sec
Holding 'C '3 sec
Figure 7-1 ACU Front Keypad
CONFIG: SHIP LOCATION
CONFIG: SHIP HEADING
CONFIG: SAT. FINDING METHOD
CONFIG: POLARITY
CONFIG: S&T REF DETAILS
CONFIG: DVB TUNER
CONFIG: TEMP S&T REF TEST
CONFIG: YAW AXIS INITIALIZE
CONFIG: SEARCHING ON/OFF
CONFIG: TRACKING ON/OFF
CONFIG
: STR ID
STATUS of all searching and tracking references
Go to INSTALLATION MODE
Monitor and Control using PC
Table 7-1 Key Mapping (Quick Reference)
Action
62