7.2
Installation Mode
If you push and hold the "ß" key in the main display for 2~3 seconds, you can enter the
'Installation Mode'. The 'Installation Mode' has 17 sub menus. Use this mode when
replacing any board or hardware, or when changing the gyro type, etc.
NOTE: You must save the changed parameters when you change any parameter to the
desired parameter. If the new parameters are not saved, they will be lost the next time the
ACU is power cycled, and the previous parameters will be restored.
7.2.1 Bluetooth Initialize
The antenna and the ACU communicate with each other using Bluetooth via an RX
cable. When the Bluetooth module is replaced, it is necessary to pair the Bluetooth.
Please refer to the 'Bluetooth Communication' section of 'Initial Configuration'.
Figure 7-24 Pairing the Bluetooth
78