Nmea Strip Connector; Console Port - KNS Ku-BAND TX Installation And Operation Manual

3.6.1.5
If the ship's gyro is of the NMEA type, the installer can use an NMEA strip connector. X1,
X2, NO are not available.
Figure 3-21 Layout of the NMEA Strip Connector Pins
NOTE: Do not use the NMEA strip and the DB-15 gyro connector at the same time as
this may damage the ACU.
3.6.1.6
The RJ-45 console port provides the following: Transmits GPS information and
transmits Mute, receives TX lock and external AGC values (0~5 VDC).
Table 3-3 shows the pins of RJ-45 console port. The signal directions are referenced
either into (RX) or out from (TX) the port.
Table 3-3 Layout of the ACU RJ-45 Interface Pins

NMEA Strip Connector

RJ-45 Console Port
RJ-45 (DTE)
2
4
5
6
7
8
All Other Pins
Type
RX Lock
GND
GND
GPS
TX Mute
Ext AGC
N/A
22