M&C Port Connection; Ethernet Port - KNS Ku-BAND TX Installation And Operation Manual

3.6.3.6 M&C Port Connection
Use the M&C port when monitoring and configuring the antenna using the PC and SCS
ver 1.7.2 This requires the installation of a serial cable or Mini USB-to-Serial cable for
communication between the two devices. Remember that the baud rate of the M&C Port is
fixed at 57600.

3.6.3.7 Ethernet Port

Both installer and operator can access to the ACU from outer devices using the Ethernet.
You must configure the host IP address, gateway, and subnet-mask to use the Ethernet.
We provide remote access software (SCS V1.7.2 & TMonitor) to the dealer. If you wish to
obtain this software, please contact us.
M&C DB-9 Pin No.
2
3
5
All other pins
Table 3-9 Layout of M&C Port Pins
Type
Receive Data
Send Data
GND
NA
31