X-Tra Active Speaker Kit - Bang & Olufsen BEOLINK Handbook

X-tra active speaker kit

Trouble
Operation from the link room is
possible, but no sound in the link
room.
No sound in the link room.
Operation from the link room not
possible.
When operating the system in a
link room, other link rooms
and/or the main room are
activated.
MASTER CONTROL LINK
Possible cause
A) The active speakers are not connected to the mains.
B) The switches on the active speakers are not set properly.
C) MCL cable is mounted incorrectly in the terminal strip on the MCL
2AV panel. (Check that green, yellow, grey & brown leads are
correctly mounted in the terminal strip.)
D) Power Link cable between speakers and MCL 2AV panel is
disconnected.
A) The MCL 2AV panel is not connected to the mains.
B) MCL cable is not mounted or incorrectly mounted in the Beomaster.
Check that the L & R speaker plugs are properly mounted in the
Beomaster.
White lead = right (R)
Black lead = left (L)
C) The data lead (white) in the MCL cable is disconnected or short
circuited.
(Check terminal strip.)
D) The transceiver picks up noise from e.g. dimmer or light source. (See
section on placing of transceiver.)
E) Error in transceiver, MCL 2AV panel or mains adaptor.
A) The information from the terminal can be "seen" from the other
rooms, which are then activated. (See the section on placing of
transceiver, or use "Option 4" as described in the section on special
setups.)
33