Page 2
Video kit, we recommend the This guide describes how to in- The BeoLink distribution system following sequence: stall your BeoLink Video kit in enables you to control any 1 Switch off all products and a BeoLink distribution system. source in your main system and disconnect from the mains.
Page 3
The main room is the room in which you have placed your audio system and/or video sys- tem (the main system). The link room is where you place your extra TV (connected to the main system through the BeoLink installation). Note: Building and electrical codes vary from locality to locality.
Page 4
AUDIO AUX LINK on the Beo- Link Video box and the other Placement to the socket, marked AUDIO The BeoLink Video box must be AUX LINK (or LINE) on your placed in a dry place, i.e. not extra TV. outdoors (the cables, however, In the main room: Using a Beo- may very well be run outdoors).
Page 5
TV to the careful not to twist them. mains – before connecting the Avoid subjecting the cables to BeoLink Video box to the pressure or impact. mains!
Page 6
R E A D Y F O R U S E … Before you start using the sys- Beovision model: Programming sequence: tem, a few steps related to your MX 7000/6000/4000 (Beo4) Hold the • button while pressing particular setup must be carried LIST.
Page 7
Beovision MX 7000/6000/4000 labelled BEO4 • Select LINK, TV on the Beo4. on the rear cover and no second video • Tune the TV to the video transmission frequency of tape recorder in the main system the main system and store this frequency on P60. Beovison MX as mentioned above and a •...
Page 8
Printed in Denmark by 3500xxx 0986 Bogtrykkergården a-s, Struer...
Need help?
Do you have a question about the BEOLINK VIDEO and is the answer not in the manual?
Questions and answers