Home Theater Master MX-500 Operating Manual page 34

Lcd screen preprogrammed and learning remote control

Hide thumbs Also See for MX-500:

5. If you pressed the

button, it will show all

the devices. Press the device button you wish to clone.

6. Set the MX-500TM head to head with another MX-

500TM to be cloned from as shown below. The both units

should be in either cloning from or cloning to mode

based on the selection in Step 3.

7. Press the 5

button for the both units to execute.

It will take about 40 seconds to complete the cloning

and it will flash "GOOD" upon completion of cloning.

If it flashes "FAIL", repeat from Step 2.

8. Exit from cloning mode by pressing t

button and then exit from SET UP mode

ng the

button once again.

and

button of joystick simultaneously

the LCD contrast darker and pressin

tton of joystick simultaneously will

contrast lighter.