Home Theater Master MX-500 Operating Manual page 18

5. Press the button on your original remote control
you wish to program into the MX-500TM. Once the
MX-SOOTM has received the signal, the MX-500TM
will flash "Good" on the LCD screen, indicating it
learned the code correctly. If it flashes "Fail", repeat
from Step 4 until it learns successfully. (Please
enter the code signal within 20 seconds of
programming).
6. Once you complete the programming and wish
to exit the leaning mode, press the I%$ utton.
Exit from SET UP mode by pressing t
button once again.
2. Programming the Ten Device Buttons
1. Go to the program setting mode by pressing both
the IN and buttons simultaneously for
three seconds.
4. Press any of the ten device buttons you wish to
program into the MX-500rM and place your original
remote control head to head with the MX-500TM
about 2 inches apart on a flat surface.