Home Theater Master MX-500 Operating Manual page 30

Lcd screen preprogrammed and learning remote control

Hide thumbs Also See for MX-500:

3. Press the device button you wish to write a text on

the LCD.

Tip) To edit the text on device button, press the ~~~~

button and then press oy2e of the ten device buttons, you

wish to edit.

4. Press the LCD button on which you wish to create

text. You can also go to the second page of LCD by

pressing the ~~~~ button.

5. The character to be changed will blink and you can

select the character using the number pad on the remote

control. The characters assigned to each number pad

button are shown below. It will be rotated to a different

character each time the same number pad is pressed.

Tip) You can move the cursor left or right using the

joystick. You can also erase a current character by

pressing cursor down of the joystick.

1.m1

2.-j

3.m

4.m

5-1

6. P Q R 6

7. S T U 7

S./vlwlxll

9.I~I~191blankI

0.101 ! I~ldl~l~l~l

II)WIM

/#I&I(I)I+I-I.I/I_I"I

6. Save the text you created by pressing the button you

were writing on again(the same function button you

selected in step 4).

7. Exit from Edit mode by pressing the ~~~

button

and then exit from SET UP mode by pressing the

button once again.