Top Panel: Wireless Receiver Controls - Lightspeed Delta X6 User Manual

Transportable public address system
Hide thumbs Also See for Delta X6:
Table of Contents

Advertisement

TOP PANEL: WIRELESS RECEIVER CONTROLS

1. WIRELESS RECEIVER:
One or two wireless
receiver modules are
located at the top panel.
2. CHANNEL DISPLAY:
An LED readout of
the receiver module
indicates which channel
you are on.
3. CHANNEL CONTROL
The left button
(0-99):
controls the number on the
left (0-9). Each touch of the
button moves the number up one until it gets to nine, and then it
cycles back to zero. The right button has the same function for the number on the right.
4. RF CHANNEL A/B INDICATOR:
strongest RF signal. The B lights up indicating the B channel tuner is receiving the strongest
RF signal.
5. TRANSMITTER LOW BATTERY INDICATOR:
corresponding transmitter are low.
Press this button to automatically select a channel that is free from interference.
6. SCAN:
7
. SqUELCH ADjUSTMENT:
squelch is adjusted at the factory to provide the best signal level and minimum noise. There is no
need to adjust the squelch level in the field.
8
. RECEIVER POWER/VOLUME ADjUSTMENT:
plastic cap. The volume is adjusted at the factory to provide the best signal level and minimum
noise. There is no need to adjust the receiver volume in the field.
Helpful Hint
Installing or replacing a receiver module:
NOTE: Make sure the Delta X6 is turned off.
1. Remove
the two screws securing the module panel using a
small phillips head screwdriver.
the module from the enclosure by carefully inserting
2. Remove
the blade of a small, flat-blade screwdriver under the face
plate edge and nudging it upward.
the edges of the module with both hands and slide
3. Grasp
it out.
4. Install
the new module by aligning it with the guide rails and
sliding all the way in to engage the connector at the rear of
the module.
5. Replace the two screws.
3 | Delta X6 User Manual
1
3
1
The A lights up indicating the A channel tuner is receiving the
This LED will light to indicate the batteries in the
The SQUELCH LEVEL ADJUSTMENT is covered with a plastic cap. The
The receiver volume adjustment is covered with a
D e l t a X 6 U s e r M a n u a l
2
4
7
6
5
LOW
BAT
LOW
BAT
8

Advertisement

Table of Contents
loading

Table of Contents