Replacing The Batteries; Recharging The Batteries - Lightspeed Delta X6 User Manual

OPERATING INSTRUCTIONS: HANDHELD MICROPHONE

Replacing the Batteries:

1. Unscrew the end cap to reveal the battery
compartment.
2. Remove or replace the batteries as shown. The
microphone requires two AA sized batteries
stacked end to end.
3. Note the polarity in the battery compartment.
IMPORTANT: Replace batteries with the same
type, (alkaline or NiMH), that were installed
in your Handheld Microphone. Lightspeed
recommends Panasonic or Energizer batteries.
Duracell may not work properly.
Recharging the Batteries (NiMH Rechargeable Batteries ONLY):
Make sure there are NiMH rechargeable batteries in the transmitter before
plugging in the charger.
WARNING: Do not attempt to charge alkaline
batteries. They can overheat and expand,
creating a significant hazard and damaging the
transmitter. (This is not covered by warranty.)
1. Switch the transmitter power OFF.
2. Insert the small DC plug into the jack on the bottom of
the transmitter.
3. Plug the other end of the charger into any standard 110 VAC outlet.
4. The RED LED on the charger will light, indicating that charging is in progress.
5. When the batteries are fully charged, the LED on the charger will glow GREEN.
Helpful Hint
• A full charge will be attained in 8-10 hours
• Fully charged Lightspeed microphones will last over 7 hours
D e l t a X 6 U s e r M a n u a l
Delta X6 User Manual | 14
PWR PWR
DN DN UP UP