Channel Selection - Lightspeed Delta X6 User Manual

OPERATING INSTRUCTIONS: BELT-PACK TRANSMITTER

Channel Selection:

Once a channel has been selected on the receiver, you now
need to select that same channel on the Belt-pack transmitter.
Helpful Hint
Transmitters and receivers are available in
3 different frequency groups. Verify that
the letter code that blinks on the receiver
(when powered ON) matches the letter
code on the silver sticker in the battery
compartment of the transmitter.
1. Turn the transmitter power ON
by pressing the and holding the
PWR button on the side for about
two seconds. The LCD display will
appear.
2. Open the battery compartment
door by depressing the latches on
each side of the transmitter.
3. Use the UP and DN buttons to
select a screen that shows the
current channel.
4. To change the channel, press and
hold the SET button for about 3
seconds until there is a blinking
cursor on the LCD display window.
5. Use the UP and DN buttons to set
the channel to match the receiver.
6. Press and hold the SET button
again for about 3 seconds until the
blinking cursor disappears.
NOTE: To read the frequency
in MHz, press UP once
CH: 002
CH: 002
694.500M
.
NiMH
AKLN
SENS SET
LEVEL [2]
D e l t a X 6 U s e r M a n u a l
LightSPEED
CHANNEL
LOW
BAT
Model Number: BP900
Serial Number
BP90014324024
FREQUENCY L-670 MADE IN TAIWAN
Delta X6 User Manual | 16
7100R
UHF TRUE
DIVERSITY
RECEIVER
A B
RF SCAN SQ
7