Replacing The Batteries; Recharging The Batteries - Lightspeed Delta X6 User Manual

OPERATING INSTRUCTIONS: BELT-PACK TRANSMITTER

Replacing the Batteries:

1. Open the battery compartment door by
depressing the latches on each side of the
transmitter.
2. Remove or replace the batteries and snap the
door shut. The belt-pack requires two AA sized
batteries.
3. Note the polarity in the battery compartment.
IMPORTANT: Replace batteries with the same
type, (alkaline or NiMH), that were installed
in your Handheld Microphone. Lightspeed
recommends Panasonic or Energizer batteries.
Duracell may not work properly.
Recharging the Batteries (NiMH Rechargeable Batteries ONLY):
Make sure there are NiMH rechargeable batteries in the transmitter
before plugging in the charger.
WARNING: Do not attempt to charge alkaline
batteries. They can overheat and expand,
creating a significant hazard and damaging the
transmitter. (This is not covered by warranty.)
1. Switch the transmitter power OFF.
2. Insert the small DC plug into the jack on the side of the transmitter.
3. Plug the other end of the charger into any standard 110 VAC outlet.
4. The RED LED on the charger will light, indicating that charging is in progress.
5. When the batteries are fully charged, the LED on the charger will glow GREEN.
Helpful Hint
• Typical battery life is about 8 hours.
• A full charge will be attained in 8-10 hours
• Fully charged Lightspeed transmitters will last over 7 hours
19 | Delta X6 User Manual
D e l t a X 6 U s e r M a n u a l