Equipment Interface Status Led; Navigating The Smart Thermostat - Ecobee Smart Thermostat Installation Manual

Equipment Interface Status LED

The Equipment Interface has four LEDs to display the status
of the system.
If you've wired the system correctly, only the Power LED should be on.
Power
System
Line
Communication
The LEDs operate as follows:
Power
This LED monitors the power supply of the Equipment Interface.
LED ON Power is connected to the Equipment Interface and is
within the appropriate voltage range.
LED OFF Power is disconnected or has dropped below 9V.
System
This LED monitors the operation of the Equipment Interface.
LED ON There is a fault with the Equipment Interface.
LED OFF The equipment interface is operational.
line
This LED monitors the power supplied to the Smart Thermostat from
the Equipment Interface.
LED ON The voltage at the +12V and GND terminal has
dropped below 7V.
LED OFF Adequate power is being supplied to the
Smart Thermostat.
15
LED arrangement
Communications
This LED monitors the communications between the Smart Thermostat
and the Equipment Interface (i.e., the D+ and D- terminals).
LED ON The Equipment Interface and Smart Thermostat are
not communicating to each other.
LED OFF The two devices are communicating properly.
NAvIGATING THE
SMART THERMOSTAT
Once the Smart Thermostat and Equipment Interface are powered up
and working correctly, you can begin configuring the system.
The Smart Thermostat uses touch screen technology, so it's easy to
navigate – just tap the icons, buttons and lists.
Note: To prevent damage to the touch screen, never use a sharp object
such as a pen, to press the icons, buttons and lists.
When the screen shows a list setting an arrow on the right indicates
more than two options to choose from.
If there is no arrow, then the list item only has two options. Toggle
between options by pressing the list item.
In the various screens, you have three navigation choices:
Press Done to save changes and move to the next screen.
Press Cancel to go back to the previous screen without
saving changes.
At any time press the Home button (found on the right hand side
of the touch screen). This cancels any action and takes you back
to the home screen.
If you are required to enter data in the form of text, you will be
presented with a keyboard.
Pressing the Caps key will allow you to enter capital letters, and
pressing the 123@ key will change the letters to numbers or
commonly used symbols.
16