Sony XDS-1000 Operation Manual page 128

Alarm message in status
display area
CF Warning
Alarms relating to the internal storage
Alarm message in status
display area
HDD(1/2/3) Warning
HDD(1/2/3) Fail
Rebuilding xx%
CONFIG MIS
Low Remaining Capacity
Other alarms
Alarm message in status
display area
Turn off/on POWER!!
Turn off/on POWER!!
128
Troubleshooting
Alarm message in video monitor screen Description/action
IT IS NECESSARY TO REPLACE CF
DISK. PLEASE CONTACT SERVICE.
Alarm message in video monitor screen Description/action
ERRORS OCCUR FREQUENTLY WHILE
READING/WRITING HDD NUMBER (1/2/
3).
PLEASE CONTACT SERVICE.
HDD(1/2/3) FAIL.
PLEASE CONTACT SERVICE.
REBUILDING NOW.
PLEASE DO NOT TURN OFF.
INTERNAL STORAGE CONFIGURATION
MISMATCH.
–
Alarm message in video monitor screen Description/action
SYSTEM CONFIGURATION WAS
CHANGED.
PLEASE TURN OFF/ON POWER.
MENU CONFIG WAS CHANGED.
PLEASE TURN OFF/ON POWER.
Contact your Sony service or sales representative.
Note
The unit will operate, but if you continue to use it, the
CF disc may be damaged and all information may be
lost.
Errors are occurring frequently when reading or
writing an HDD (1, 2, or 3). The hard disk drive must
be replaced.
Contact your Sony service or sales representative.
An HDD (1, 2, or 3) had malfunctioned. The HDD
must be replaced.
Contact your Sony service or sales representative.
Data is being rebuilt.
Do not power the unit off until the rebuild has finished.
Check whether the required number of hard disk
drives is installed. If that does not solve the problem,
contact your Sony service or sales representative.
The internal storage has low remaining free space.
Delete any unwanted clips.
The system frequency was changed.
Power off this unit and then power it on again.
Menu settings were changed.
To put the change of menu settings into effect, power
this unit off and then power it on again.