Sony XDS-1000 Operation Manual page 116

Item
M40: EXTENDED MENU
M48: AUTO RECALL
M49: RESET ALL SETUP
Item
M50: DHCP
M51: IP ADDRESS
M52: SUBNET MASK
M53: DEFAULT GATEWAY
M54: LINK SPEED
M56: JUMBO FRAME
116
Maintenance Menu
M4: SETUP MAINTENANCE: Items relating to the setup menu
Setting
Select whether to display the extended menu.
DISABLE [dis]: Do not display.
ENABLE [ena]: Display.
Select whether to recall settings automatically from a menu bank when the
system is powered on, and if so which menu bank to recall from.
off: Do not recall settings from a menu bank.
from BANK1 [Bank1]: Recall settings from menu bank 1.
from BANK2 [Bank2]: Recall settings from menu bank 2.
from BANK3 [Bank3]: Recall settings from menu bank 3.
Reset all the menu settings to the factory settings.
Push the SAVE function button (F5): Reset.
Push the MENU button: Return to the next highest menu level without resetting.
Notes
• The system frequency setting is also cleared. If you execute this item, reset the
system frequency (see page 31).
• Date and time settings are not cleared, but the time zone setting is cleared.
After executing this item, reset the time zone (see page 31).
M5: NETWORK: Items relating to network settings
Setting
Set whether to assign an IP address automatically with the DHCP server.
DISABLE [dis]: Do not assign automatically.
ENABLE [ena]: Assign automatically.
Set the IP address of this unit.
192.168.001.010
Notes
• IP address cannot be set when DHCP is set to "ENABLE".
• To check the automatically acquired IP address of this unit, close the maintenance
menu and then open it again.
Set the subnet mask.
255.255.255.000
Notes
• Subnet mask cannot be set when DHCP is set to "ENABLE".
• To check the automatically acquired subnet mask, close the maintenance menu
and then open it again.
Set the address of the default gateway.
000.000.000.000
Notes
• The address of the default gateway cannot be set when DHCP is set to "ENABLE".
• To check the automatically acquired address of the default gateway, close the
maintenance menu and then open it again.
Set the communications speed and protocol.
AUTO [auto]: Sets automatically.
1Gbps FullDuplex [1G F]: 1 Gbps, full duplex
100Mbps FullDuplex [100 F]: 100 Mbps, full duplex
100Mbps HalfDuplex [100 H]: 100 Mbps, half duplex
10Mbps FullDuplex [10 F]: 10 Mbps, full duplex
10Mbps HalfDuplex [10 H]: 10 Mbps, half duplex
a)
Set the size of jumbo frames.
4088, OFF(1514)
Note
This value does not include the 4 bytes of the FCS (Frame Check Sequence).