PP20 / PP25
AUX IN AND HEADPHONE
Using the supplied 3.5mm audio cable plug into the AUX IN jack on rear panel, and
the other terminal connect to other relative audio player. Power on the unit, and
press
button; the unit will switch to AUX mode automatically. Select the music
from your player device and play. The sound will output from the speaker. You can
turn the volume knob to adjust the volume.
In any play mode, if you insert headphone into the headphone jack on rear panel,
there will no sound output from the speaker, but via headphone. In headphone
output mode, the volume will adjust to the 18 max automatically; if you want to
increase higher volume, there will have buzz sound warn up to you in order remind
you protect your ear. If you really want to adjust higher volume, you have to wait the
end of buzz sound, then press
now. Otherwise the buzz sound will ring up about 3 seconds again. The max volume
is 28 levels once insert headphone.
SPECIFICATION
Input: FM radio, Bluetooth, AUX in, USB, SD card or TF card
Output power: RMS 3.5W
Signal to noise ratio: ≥70dBA
Distortion: ≤0.5%
Frequency response: 120HZ-20KHZ
Speaker: 2 ohm, 3 inches full range.
Battery: 3.7V/1000mAh BL-5C lithium battery
Battery playback time: 4 hours.
Input sensitivity: 550mV
Working environment: -10ºC-50 ºC
Stored environment: -20ºC ~ +70 ºC
Power consumption power: 5W
Standby power consumption: <0.5 W
button immediately; you can increase the volume
15