Black & Decker BD200TMT Instruction Manual page 8

• Position the accessory so the working edge is
away from the tool as shown in figure 3.
• Slide the accessory between the shaft and the
accessory holder making sure the accessory
fully engages the pins on the holder and is flush
with the shaft.
• Release the accessory clamp lever.
Installing/Removing Accessories
(BD200TMT & BD200MT)
• Some accessories, such as scrapers and
blades can be mounted at an angle if required
as shown in figure 4.
• A triangle shaped base, or platen, uses a hook and
loop adhesion system to attach the sanding sheets.
• Attach the sanding platen as described
under "Assembly."
• Align the edges on the sanding sheet, with
the edge of the sanding platen and press the
sanding sheet onto the platen as shown in
figure 5.
• Firmly press the base with the sanding
sheet attached against a flat surface and
briefly switch the tool on. This provides for
good adhesion between the platen and the
sanding sheet and also helps to prevent premature wear.
• When the tip of the sanding sheet becomes worn, detach the sheet from the
platen, rotate and reapply.
3
4
5
8