Black & Decker BDCH188 User Manual

Hammer drill
Hide thumbs Also See for BDCH188:


Quick Links



Table of Contents

Summary of Contents for Black & Decker BDCH188

  • Page 1 BDCH188
  • Page 3: Intended Use

    Water entering a power tool will increase the risk of electric shock. Your BLACK+DECKER BDCH188 - Hammer Drill has d. Do not abuse the cord. Never use the cord for been designed for drilling in wood, metal, plastics, and carrying, pulling or unplugging the power tool.
  • Page 4 ENGLISH (Original instructions) f. Dress properly. Do not wear loose clothing or different from those intended could result in a jewellery. Keep your hair, clothing and gloves hazardous situation. away from moving parts. Loose clothes, jewellery or long hair can be caught in moving parts. 5.
  • Page 5: Safety Of Others

    (Original instructions) ENGLISH Hold power tool by insulated gripping surfaces, Even with the application of the relevant safety regulations when performing an operation where the fastener and the implementation of safety devices, certain residual may contact hidden wiring. Fasteners contact- risks can not be avoided.
  • Page 6: Additional Safety Instructions For Batteries And Chargers

    Labels on tool Electrical safety The following symbols are shown on the tool along with Your charger is double insulated; therefore no the date code: earth wire is required. Always check that the mains voltage corresponds to the voltage on Warning! To reduce the risk of injury, the user the rating plate.
  • Page 7 (Original instructions) ENGLISH Open the chuck (4) by turning the front part with one Charge discharged batteries within 1 week. Battery hand while holding the rear part with the other. life will be greatly diminished if stored in a discharged Insert the bit shaft into the chuck and firmly tighten the state.
  • Page 8: Maintenance

    Screwdriving Drilling in masonry (fig. D & E) For drilling in masonry, set the collar (3) to the ham- Always use the correct type and size of screwdriver mer drilling position by aligning the symbol with the bit. marking. If screws are difficult to tighten, try applying a small Slide the speed selector (5) towards the front of the amount of washing liquid or soap as a lubricant.
  • Page 9: Technical Data

    Technical data Local regulations may provide for separate collection of electrical products from the household, at municipal waste BDCH188 (H1) sites or by the retailer when you purchase a new product. Voltage BLACK+DECKER provides a facility for the collection and...
  • Page 12 Australia & New Zealand Stanley Black & Decker 82 Taryn Drive, Epping, VIC 3076 Australia Tel.1800 338 002 (Aust) or Tel. 0800 339 258 (NZ) 90620228 04/2015...

Table of Contents