Make Connections And Play; Example Connections; Preparing To Play - Korg ER-1mkII Owner's Manual

Rhythm synthesizer
Table of Contents

Advertisement

Make connections and play!

Example connections

Preparing to play

Be sure to turn off the power before making connections. Careless operation may damage your
speaker system or cause malfunctions.
1. Connect the included AC adapter to the DC 9V jack, and plug the adapter into an AC outlet.
2. Connect one end of your audio cables to the line out jacks of the ER-1
connect the other end to your mixer or powered monitor speakers (amplified speakers) etc. If you
will be listening in mono, use the L/MONO jack. To take full advantage of the ER-1
quality, we recommend that you listen in stereo.
3. If you will be using headphones, connect them to the headphone jack.
The output from the line out jacks will not be switched off even if headphones are plugged in.
4. When you have finished making connections, turn on the power. Slightly raise the master volume
of the ER-1
II, and strike the part keys (PERCUSSION SYNTHESIZER 1...4) to check whether
mk
connections have been made correctly. Use the master volume of the ER-1
fader controls of your mixer or powered monitor system to adjust the volume to an appropriate
level.
1.Introduction
II (L/MONO, R), and
mk
II's sound
mk
II and the gain and
mk
7

Advertisement

Table of Contents
loading

This manual is also suitable for:

Electribe er-1 mkii

Table of Contents