Error Messages; Restoring The Factory Set Data; Specifications - Korg ER-1mkII Owner's Manual

Rhythm synthesizer
Table of Contents

Advertisement

8.Appendices

Error messages

Er.1
Data could not be written.
Er.2
When writing a song to a different song num-
ber, the maximum number of recordable events
was exceeded. Use the Clear Event operation
to erase unwanted events from the song (p.37).
Er.9
Protect was turned "on" for the memory into
which you attempted to write data. In Global
mode, turn the Protect setting "oFF" (p.39).
Full
When event-recording on a song, event data
memory has filled up. If you attempt to record
additional events, the "memory full" message
will appear immediately. Either use Clear Event
to delete unwanted events from a song, or
record blank data to clear the memory.
Restoring the factory set
data
The pattern and song data with which the ER-1
from the factory is referred to as the "preloaded data," and you
can restore this preloaded data back into the memory of the
ER-1
II.
mk
When you do this, the patterns you created and the songs which
use these patterns will be erased, and replaced by the preloaded
data. If you wish to keep the patterns and songs you created,
you must save the data on a data filer etc. before you load the
preloaded data.
1. While simultaneously pressing the SOLO key and the WRITE
key, turn on the power.
2. The display will indicate "PLd," and the Play/Pause key will
blink.
3. To load the factory preloaded data, press the blinking Play/
Pause key.
This will require apporoximately 30 seconds.
To cancel, press the Stop/Cancel key.
When loading is complete, the ER-1
state. After several seconds the display will indicate pattern
number "A01," and the ER-1
Never turn off the power during the Load process. The
data may be damaged.
44
II is shipped
mk
II will return to its initial
mk
II will be in Pattern mode.
mk

Specifications

System:
Analog modeling + PCM
Number
11 parts
of parts:
Synthesizer parts x 4
PCM parts x 4
Audio In parts x 2
Accent part
Memory
capacity:
256 patterns, 16 songs
Effects:
Delay
Normal, Motion Sequence, Tempo Delay
Sequencer:
Pattern
Maximum 64 steps per part
Motion sequence
One parameter for each part, 64 events
Song
Maximum 256 patterns per song
Maximum 35,700 events for event
recording
PHONES
Connectors:
Stereo phone plug
Nominal level: 21 mW + 21 mW (32 ohms)
OUTPUT (L/MONO, R)
Phone jacks: mono x 2
Nominal output level: -10dBu
Output impedance: 1 k-ohms
AUDIO IN (phone jack: mono x 2)
Nominal input level: -10dBu
Input impedance: 47 k-ohms
MIDI (IN, OUT, THRU)
Power supply: DC 9 V (AC adapter included)
Power consumption:
5.5 W
Dimensions:
296(W) x 220 (D) x 55 (H) mm
(with rubber feet)
Weight:
1.5 kg

Advertisement

Table of Contents
loading

This manual is also suitable for:

Electribe er-1 mkii

Table of Contents