Configuring Web Filter For Authentication; Configuration Procedures; System Section - M86 Security M86 Web Filter User Manual

Configuring Web Filter for Authentication

Configuration procedures

When configuring the Web Filter for authentication, settings
must be made in System and Policy windows in the Admin-
istrator console.
NOTES: If the network has more than one domain, the first
you add should be the domain on which the Web Filter resides.
The entries described in this section represent entries to be made
on a typical

System section

The first settings for authentication must be made in the
System section of the Administrator console in the following
windows: Operation Mode, LAN Settings, Enable/Disable
Authentication, Authentication Settings, Authentication SSL
Certificate (if Web-based authentication will be used), and
Block Page Authentication.
1. Select "Mode" from the navigation panel, and then select
2. Select "Network" from the navigation panel, and then
M86 S U G
ECURITY SER UIDE
network.
"Operation Mode" from the pop-up menu.
The entries made in the Operation Mode window will vary
depending on whether you will be using the invisible
mode, or the router or firewall mode.
In the Listening Device frame, set the Listening Device to
"LAN1".
In the Block Page Device frame:
• If using the invisible mode, select "LAN2".
• If using the router or firewall mode, select "LAN1".
select "LAN Settings" from the pop-up menu.
C 1: I
HAPTER NTRODUCTION
A S
UTHENTICATION OLUTIONS
one
29