Manual Programming - Assa Abloy EMTEK LISCIO User Manual

The lock can be programmed manually using the keypad buttons 1 through 5. This feature is made avail-
able but programming using smart phone is highly recommended.
Manual Programming commands
A. To enter programming mode – press the #1 and the #5 buttons simultaneously
B. Enter the lock's 6 digit master code (the master code will be on sticker on page 7 of user manual
and inside trim plate of lock)
C. The features below now accessible by entering a combination of two buttons one after the other
(not simultaneously)
1. To add a code
2. To delete a code
3. To change master
code
4. Deny Users ON
5. Deny Users OFF
Deny Users can disable or enable all user codes – when ON, no user codes will work,
only key operates lock
6. Delete all codes
7. Set 4 digit code length
8. Set 6 digit code length
9. Beeper ON
10. Beeper OFF
11. Extended timeout
OFF
12. Extended timeout
ON
Extended timeout mode allows for a longer duration of unlock time upon
entry of a valid user code.
13. Passage switch OFF
14. Passage switch ON
Passage switch mode ON, choose between Passage (lock unsecured) and Privacy (always locked) and
OFF lock is always in Privacy (always locked).
15. Restore factory
defaults

Manual Programming

enter # 1 and then # 3
enter # 4 and then # 3
enter # 3 and then # 3
again
enter # 4 and then # 1
enter # 5 and then # 1
enter # 5 and then # 5
again
enter # 5 and then # 2
enter # 5 and then # 3
enter # 1 and then # 1
again
enter # 1 and then # 2
enter # 2 and then # 1
enter # 2 and then # 2
again
enter # 3 and then # 1
enter # 3 and then # 2
enter # 1 and then # 4
then enter new code and enter again to
confirm (factory setting is 4 digit mode)
then enter code to delete and enter again
to confirm
then enter new master code and enter again
to confirm
(factory setting is OFF)
(factory setting is 4 digits)
(factory setting is ON)
(factory setting is OFF)
(factory setting is ON)
enter master code to confirm
5