Product View; Entering User Codes/Restart Code Entry - Assa Abloy EMTEK LISCIO User Manual

Lever buttons
Keyed Cylinder
Using the Lock
Once installed on door with the battery connected - your lock is ready for use.
Factory Default Setting
User & Master Codes are labeled on the inside trim plate and page 7 of this user manual.
Entering User Codes
- Entering a correct, active user code (green LED x1 & beep x1) - unlocks
- Entering an incorrect or inactive code (red LED x2 & beep x2) - remains locked
- Three incorrect entries will result in lockout, signaled by 3 red LED flashes & 3 short beeps,
lockout lasts for 30 seconds.
To Restart Code Entry
Press and hold # 1 button for three seconds (this works in entry or programming mode).
Key Access
Lock may also be unlocked and locked via keyed cylinder, each lock comes with two keys.
Passage & Privacy Mode
Use inside thumbturn.
Setting
Thumbturn
Enable ON
Thumbturn
Enable OFF
2
ELECTRONIC KEYPAD LEVERSET
WITH BLUETOOTH PROGRAMMING
Setting Description
Lock access is regulated.
A correct, active user code
is required for access.
(Privacy Mode)
Lock access is NOT regulated
Always Unclocked.
(Passage Mode)
Thumbturn
Thumbturn Position LED Feedback
Green
Amber